Fensoplate composite in kit

  • Hard flexible wood composite slats to weave through your 3D or Double wire panel fence
  • available in the colors Wenge Brown or Graphite black
  • A standard kit is exactly suitable for one running meter of panel fence in the desired panel height

    • for 3D panels:

      • Before use, first check the exact mesh width of your panel (mesh 50 (free opening 45 cm) or mesh 55 (free opening 50 mm)
      • then check the depth of the bend of your panel (V-SMALL or V-LARGE)

        Check HERE what depth (d) your panel had and what kind of profile you need to order!
      • the slats with a thickness of 3 mm can be placed flat as well as woven
      • at the bottom, the slats are slid into a plastic fastening profile
      • at the top, the slats are finished with the corresponding top profile
      • the slats are additionally held in place by means of pressure clips
      • for flat installation in 3D panels, the slats are also fixed via V-shaped clamp profiles
      • each kit contains: 
        • 2 top profiles of 50 cm
        • 2 bottem profiles of 50 cm
        • the suitable number of V profiles 50 cm (V-SMALL or V-LARGE) for the desired panel height
        • 1 corner slat 35 mm
        • 20 standard slats 43mm for mesh 50 or 18 standard slats 47mm for mesh 55
        • pressure clips
    • for 8/6/8 double wire panels welded out of pre-galvanized wire and coated:

      • the slats of 3 mm thickness are simply slid vertically through the double wire panels 8/6/8 out of pre-galvanized wire and coated.
        • ATTENTION! - Hot Dip galvanized panels can cause installation difficulties due to local zinc blocks
      • at the bottom, the slats are slid into a plastic mounting profile
      • at the top, the slats are finished with the corresponding top profile
      • each kit contains: 
        • 2 top profiles of 50 cm
        • 2 bottem profiles of 50 cm
        • 1 corner slat 35 mm
        • 20 standard slats 43 mm

 

Page 1 of 3